Repositioning the table

When I affixed the table to the wall, I did use the existing beams. Unfortunately, I had not considered that for eating this places the table at an inconvenient height: at 90 cm above the ground. But better would be 70-80 cm.

But since there is then no supporting beam behind the panels, I needed to add a board onto the panels which would be affixed at those beams, and which would provide the support for the table.

Also I did move the table so that on all three sides seating could be provided.

Affixing the supporting boards at the wall, where underneath there are beams for providing places to affix the boards with screws.

The relocated table in its new position.

Table folded against the wall.